2VTLR Installation LED Relighting by Lithonia Lighting

2VTLR Installation LED Relighting by Lithonia Lighting


[music] The 2VTLR light assembly consists of a
very simple set of components that install quickly and simply to convert
nearly any parabolic or lens troffer to a highly efficient volumetric LED
luminaire and a completely refreshed appearance. Before you begin with the
installation process when working with electrical components make sure you turn
off the power at the main breaker that you wear insulated gloves and that your
eyes are properly protected. Begin the installation by preparing the host
fixture. Remove the door frame and set aside. Remove lamps and set aside for proper disposal and recycling. Remove the channel cover and disconnect
the incoming supply voltage. Remove existing fluorescent lamp holder
brackets and ballast from the channel and strip the incoming supply wires. The
fixture is now ready for installation of the 2VTLR components. Install the end
brackets by sliding the flange between the T-grid and the host then seat the
bracket firmly against the end plate of the housing. Secure the brackets to the housing with
the self-tapping tech screws included with the kit. Hang the LED light engine
from the hinge receivers on the end brackets by slotting one end and hooking
the other over the bracket. The light engine will now hang securely while the
wiring connections are made. Insert the black and white supply wires securely
into the plug-in driver connector. Self-adhesive wire management clips are
included with the kit to be used if needed to secure excess supply wire in
the channel. Hinge the light engine up into place and secure at each end with
the included screws. Note the end bracket has now positioned the LED panel at the
optimal distance from the ceiling plane regardless of the depth or type of host
fixture housing. This ensures reliable consistent appearance and performance
from fixture to fixture throughout the project. Hang the door frame assembly by
engaging the hinges into the slots on the end brackets and seating in place. Attach the bonding strap on the
doorframe to a convenient point anywhere inside the host housing with included
self-tapping screw. Close and latch the door frame. Installation is now complete.
The existing fixture has now been upgraded to the aesthetics and
performance of a brand new LED luminaire all without ever breaking the ceiling
plane. The 2VTLR T-kit with white brackets for installation and lens
troffers is shown here. For installation in parabolic fixtures the 2VTLR
kit has black brackets to match the black reveal frame of the host housing. When the 2VTLR kit is installed in
some lens troffers there may be a gap between the doorframe and T-grid. For
these instances the 2VTLRT is supplied with two flexible trim strips
that are designed to fill this gap for a cleaner installed appearance. With the
door frame removed slide one end of the flexible strip between the end bracket
and the host housing. The notch on the end of the strip will align with the end
bracket. Secure the strip and smooth into place then repeat along the other side
of the fixture. When the door frame is now installed and closed the gap will be
eliminated for a finished clean appearance. [music]


One thought on “2VTLR Installation LED Relighting by Lithonia Lighting

Leave a Reply

Your email address will not be published. Required fields are marked *